Yesterday I finally got to brew my Belgian Triple. I still need to think of a good name for it and I am taking suggestions. I recieved all of my ingredients from Austin Homebrew on Wednesday and quickly discovered that I had a few problems. The first was that the Wyeast 1214 Belgian Ale yeast was warm to hot. The summers here in Texas get scorching and the trip from Austin to Lubbock is a long hot one. I did order an ice pack, but that too was warm by the time it got here. The second was that Tettnanger and Saaz came in 2-3% less than what I was anticipating. I modified the recipe a bit to get similar IBUs out of the brew. I also change a few of the times in the mash and hopping schedule.
Friday morning, around 9:30 or so, I smacked the pack to get the yeast woken up. I didn’t plan on actually starting the brew till 4:00 in the afternoon so that gave it plenty of time to puff up. The smack pack never really puffed up much past the first 2 hours. You can see in the picture to the left that it didn’t to much. I was a bit concerned but decided that it was too late to change anything.
I mashed my grains (12 lbs Belgian Pils, .5 lbs Belgian Pale, and .5 lbs unmalted wheat) for 90 minutes at 152ºF. The strike water temperature came in at 165ºF. After the 90 minutes I took the temperature again just to see how good my new mashtun held temps. The theomerter read 150ºF! I was pretty pleased what that result. I was acutally expecting it to drop much more than that.
I collected about 2.5 gallons of water from my orginal 4 gallons. I added another 3 gallons of water that came in at 170ºF. I collected my second runnings in the main boil pot and about a gallon of third runnings in a secondary pot. The point of this is to add it to the main pot once some of it boils away. I only have a 5 gallon pot, so trying to get the most out of it is tough. This is the method I have been using and it has worked. It also allows me to get the most out of the grains that I can.
I boiled each pot for 30 minutes and then combined them. I also added 1 oz. of the Tettnanger at this time. I continued the boil for another 30 minutes and added .5 oz of Saaz hops. 15 minutes later I added another .5 oz of Saaz and 5 minutes after that I added a BrewVint Yeast Fuel. Finished out the boil for another 10 minutes and started the cooling process. 90 minute total boil. When all was said and done I had collected just under 4 gallons of wort, I was shooting for 3.5 gallons, and had a gravity of 1.074.
I was pretty happy with that, but it fell short of the gravity I wanted. Part of that was due to the increased wort volume and I think Beer Tools Pro overestimated the amount of sugar I would be able to get. I didn’t add anything to bring the gravity up to where I wanted it becasue I wasn’t sure about the health of the yeast. I pitched the yeast closed it all up and went over to a friends. I came back 4 hours later and the airlock was bubbling away. Success! The beer isn’t going to be as strong as I had intended but that’s ok. This is my first ever big beer and I am happy with the results thus far. If I would of done some more thinking and planning I would of tried to make a session beer with whatever sugars were left in the grain bed. Something to consider next time.
The Tripel should be in the primary for a week and the secondary for another week. Then it is bottling time. My apartment stays at a pretty consitent 75ºF so it should be just fine. And finally my new brewing partner enjoying all of the new smells. If you click the read more link after this you can see some more pictures from the brew day. (more…)